SNIP_CLASSIC_ADC_SECTION_8_3_3_Adc_DeInit

8.3.3 Adc_DeInit [SWS_Adc_00366] Definition of API function Adc_DeInit ⌈ Service Name Adc_DeInit Syntax void Adc_DeInit ( void ) Service ID [hex] 0x01 Sync/Async Synchronous Reentrancy Non Reentrant Parameters (in) None Parameters (inout) None Parameters (out) None Return value None Description Returns all ADC HW Units to a state comparable to their power on reset state. Available via Adc.h ⌋ [SWS_Adc_00110] Upstream requirements: SRS_SPAL_12163 ⌈The function Adc_DeInit shall return all ADC HW Units to a state comparable to their power on reset state. Values of registers which are not writeable are excluded. It’s the responsibility of the hardware design that this state does not lead to undefined activities in the µC.⌋ [SWS_Adc_00111] Upstream requirements: SRS_BSW_00336, SRS_SPAL_12163 ⌈The function Adc_DeInit shall disable all used interrupts and notifications.⌋ [SWS_Adc_00358] ⌈The ADC module’s environment shall not call the function Adc_ DeInit while any group is not in state ADC_IDLE.⌋ [SWS_Adc_00228] Upstream requirements: SRS_BSW_00171 ⌈The function Adc_DeInit shall be pre compile time configurable On/Off by the configuration parameter: AdcDeInitApi.⌋ [SWS_Adc_00112] ⌈If calledwhile not all groups are either in state ADC_IDLE or state ADC_STREAM_COMPLETED, while no conversion is ongoing (ADC groups which are implicitly stopped), the function Adc_DeInit shall report a runtime error.⌋ [SWS_Adc_00154] Upstream requirements: SRS_BSW_00406, SRS_BSW_00386, SRS_SPAL_12448 ⌈If development error detection for the ADC module is enabled: if called before the module has been initialized, the function Adc_DeInit shall raise development error ADC_E_UNINIT and return without any action.⌋