SNIP_CLASSIC_CANTRCV_SECTION_8_3_15_CanTrcv_DeInit

8.3.15 CanTrcv_DeInit [SWS_CanTrcv_91001] Definition of API function CanTrcv_DeInit Upstream requirements: SRS_Can_01108, SRS_BSW_00336 ⌈ Service Name CanTrcv_DeInit Syntax void CanTrcv_DeInit ( void ) Service ID [hex] 0x10 Sync/Async Synchronous Reentrancy Non Reentrant Parameters (in) None Parameters (inout) None Parameters (out) None Return value None Description De-initializes the CanTrcv module. Available via CanTrcv.h ⌋ [SWS_CanTrcv_91002] Upstream requirements: SRS_Can_01108 ⌈The function CanTrcv_DeInit shall de-initialize all the connected CAN transceivers based on their de-initialization sequences.⌋ [SWS_CanTrcv_91003] Upstream requirements: SRS_Can_01108 ⌈The function CanTrcv_DeInit shall set the CAN transceiver hardware to the state NOT_ACTIVE.⌋ In the state NOT_ACTIVE, the CAN transceiver hardware allows to be re-configured with a new configuration sequence [SWS_CanTrcv_91004] Upstream requirements: SRS_BSW_00369 ⌈If there is no/incorrect communication towards the transceiver, the function CanTrcv_DeInit shall report the runtime error CANTRCV_E_NO_TRCV_CONTROL code to the Default Error Tracer. For Eg., there are different transceiver types and different access ways (port connection, SPI). This runtime error should be signaled if you detect any miscommunication with your hardware. Depending on connection type and depending on your transceiver hardware you may not run in situations where you have to signal this error.⌋ [SWS_CanTrcv_91005] Upstream requirements: SRS_BSW_00369 ⌈If development error detection for the CanTrcv module is enabled: The function CanTrcv_DeInit shall raise the error CANTRCV_E_TRCV_NOT_STANDBY if the transceiver is not in mode CANTRCV_TRCVMODE_STANDBY or CANTRCV_TRCVMODE_SLEEP.⌋