SNIP_CLASSIC_CAN_SECTION_8_3_2_10_Can_GetCurrentTime

8.3.2.10 Can_GetCurrentTime [SWS_CAN_91026] Definition of API function Can_GetCurrentTime Status: DRAFT Upstream requirements: SRS_Can_01181 ⌈ Service Name Can_GetCurrentTime (draft) Syntax Std_ReturnType Can_GetCurrentTime ( uint8 ControllerId, Can_TimeStampType* timeStampPtr ) Service ID [hex] 0x32 Sync/Async Synchronous Reentrancy Non Reentrant Parameters (in) ControllerId Index of the addresses CAN controller. Parameters (inout) None Parameters (out) timeStampPtr current time stamp Return value Std_ReturnType E_OK: successful E_NOT_OK: failed Description Returns a time value out of the HW registers according to the capability of the HW Important Note: Can_GetCurrentTime may be called within an exclusive area. Tags: atp.Status=draft Available via Can.h ⌋ [SWS_Can_00521] Status: DRAFT ⌈If development error detection is enabled: the function shall check that the service Can_Init was previously called. If the check fails, the function shall raise the development error CAN_E_UNINIT.⌋ [SWS_Can_00522] Status: DRAFT ⌈If development error detection is enabled: the function shall check the parameter ControllerId for being valid. If the check fails, the function shall raise the development error CAN_E_PARAM_CONTROLLER.⌋ [SWS_Can_00523] Status: DRAFT ⌈If development error detection is enabled: the function shall check the parameter timeStampPtr for being valid. If the check fails, the function shall raise the development error CAN_E_PARAM_POINTER.⌋ [SWS_Can_00524] Status: DRAFT ⌈The function shall be pre-compile time configurable On/Off by the configuration parameter: CanGlobalTimeSupport.⌋