SNIP_CLASSIC_CAN_SECTION_8_3_2_11_Can_EnableEgressTimeStamp

8.3.2.11 Can_EnableEgressTimeStamp [SWS_CAN_91025] Definition of API function Can_EnableEgressTimeStamp Status: DRAFT Upstream requirements: SRS_Can_01181 ⌈ Service Name Can_EnableEgressTimeStamp (draft) Syntax void Can_EnableEgressTimeStamp ( Can_HwHandleType Hth ) Service ID [hex] 0x33 Sync/Async Synchronous Reentrancy Non Reentrant Parameters (in) Hth information which HW-transmit handle shall be used for enabling the time stamp. Note: This is the smallest granularity which can be added for enabling the timestamp, at HTH level, without affecting the performance. Parameters (inout) None Parameters (out) None Return value None Description Activates egress time stamping on a dedicated HTH. Some HW does store once the egress time stamp marker and some HW needs it always before transmission. There will be no "disable" functionality, due to the fact, that the message type is always "time stamped" by network design. Tags: atp.Status=draft Available via Can.h ⌋ [SWS_Can_00525] Status: DRAFT ⌈If development error detection is enabled: the function shall check that the service Can_Init was previously called. If the check fails, the function shall raise the development error CAN_E_UNINIT.⌋ [SWS_Can_00526] Status: DRAFT ⌈If development error detection for the Can module is enabled: The function Can_Write shall raise the error CAN_E_PARAM_HANDLE and shall return E_NOT_OK if the parameter Hth is not a configured Hardware Transmit Handle.⌋ [SWS_Can_00527] Status: DRAFT ⌈The function shall be pre compile time configurable On/Off by the configuration parameter: CanGlobalTimeSupport.⌋ [SWS_Can_00528] Status: DRAFT ⌈Caveat: The function requires previous controller initialization (Can_Init).⌋