SNIP_CLASSIC_CAN_SECTION_8_3_2_4_Can_EnableControllerInterrupts

8.3.2.4 Can_EnableControllerInterrupts [SWS_Can_00232] Definition of API function Can_EnableControllerInterrupts Upstream requirements: SRS_BSW_00312 ⌈ Service Name Can_EnableControllerInterrupts Syntax void Can_EnableControllerInterrupts ( uint8 Controller ) Service ID [hex] 0x05 Sync/Async Synchronous Reentrancy Reentrant Parameters (in) Controller CAN controller for which interrupts shall be re-enabled Parameters (inout) None Parameters (out) None Return value None Description This function enables all allowed interrupts. Available via Can.h ⌋ [SWS_Can_00050] Upstream requirements: SRS_Can_01043 ⌈The function Can_EnableControllerInterrupts shall enable all interrupts that must be enabled according the current software status.⌋ [SWS_Can_00202] applies to this function. [SWS_Can_00208] ⌈The function Can_EnableControllerInterrupts shall perform no action when Can_DisableControllerInterrupts has not been called before.⌋ See also implementation example for “Can_DisableControllerInterrupts”. [SWS_Can_00209] ⌈If development error detection for the Can module is enabled: The function Can_EnableControllerInterrupts shall raise the error CAN_E_UNINIT if the driver not yet initialized.⌋ [SWS_Can_00210] ⌈If development error detection for the Can module is enabled: The function Can_EnableControllerInterrupts shall raise the error CAN_E_PARAM_CONTROLLER if the parameter Controller is out of range.⌋