SNIP_CLASSIC_CAN_SECTION_8_3_2_5_Can_CheckWakeup

8.3.2.5 Can_CheckWakeup [SWS_Can_00360] Definition of API function Can_CheckWakeup ⌈ Service Name Can_CheckWakeup Syntax Std_ReturnType Can_CheckWakeup ( uint8 Controller ) Service ID [hex] 0x0b Sync/Async Synchronous Reentrancy Non Reentrant Parameters (in) Controller Controller to be checked for a wakeup. Parameters (inout) None Parameters (out) None Return value Std_ReturnType E_OK: API call has been accepted E_NOT_OK: API call has not been accepted Description This function checks if a wakeup has occurred for the given controller. Available via Can.h ⌋ [SWS_Can_00361] ⌈The function Can_CheckWakeup shall check if the requested CAN controller has detected a wakeup. If a wakeup event was successfully detected, reporting shall be done to EcuM via API EcuM_SetWakeupEvent.⌋ [SWS_Can_00362] ⌈If development error detection for the Can module is enabled: The function Can_CheckWakeup shall raise the error CAN_E_UNINIT if the driver is not yet initialized.⌋ [SWS_Can_00363] ⌈If development error detection for the Can module is enabled: The function Can_CheckWakeup shall raise the error CAN_E_PARAM_CONTROLLER if the parameter Controller is out of range.⌋