SNIP_CLASSIC_COMSTACK_SECTION_8_3_4_4_PduR__User_LoTp_CopyTxData

8.3.4.4 PduR_<User:LoTp>CopyTxData [SWS_PduR_00518] Definition of callback function PduR_<User:LoTp>CopyTx Data Upstream requirements: SRS_GTW_06026, SRS_GTW_06121, SRS_BSW_00310 ⌈ Service Name PduR_<User:LoTp>CopyTxData Syntax BufReq_ReturnType PduR_<User:LoTp>CopyTxData ( PduIdType id, const PduInfoType* info, const RetryInfoType* retry, PduLengthType* availableDataPtr ) Service ID [hex] 0x43 Sync/Async Synchronous Reentrancy Reentrant id Identification of the transmitted I-PDU. info Provides the destination buffer (SduDataPtr) and the number of bytes to be copied (SduLength). If not enough transmit data is available, no data is copied by the upper layer module and BUFREQ_E_BUSY is returned. The lower layer module may retry the call. An SduLength of 0 can be used to indicate state changes in the retry parameter or to query the current amount of available data in the upper layer module. In this case, the Sdu DataPtr may be a NULL_PTR. Parameters (in) retry This parameter is used to acknowledge transmitted data or to retransmit data after transmission problems. If the retry parameter is a NULL_PTR, it indicates that the transmit data can be removed from the buffer immediately after it has been copied. Otherwise, the retry parameter must point to a valid RetryInfoType element. If TpDataState indicates TP_CONFPENDING, the previously copied data must remain in the TP buffer to be available for error recovery. TP_DATACONF indicates that all data that has been copied before this call is confirmed and can be removed from the TP buffer. Data copied by this API call is excluded and will be confirmed later. TP_DATARETRY indicates that this API call shall copy previously copied data in order to recover from an error. In this case TxTpDataCnt specifies the offset in bytes from the current data copy position. Parameters (inout) None Parameters (out) availableDataPtr Indicates the remaining number of bytes that are available in the upper layer module’s Tx buffer. availableDataPtr can be used by TP modules that support dynamic payload lengths (e.g. FrIsoTp) to determine the size of the following CFs. ▽ △ Return value BufReq_ReturnType BUFREQ_OK: Data has been copied to the transmit buffer completely as requested. BUFREQ_E_BUSY: Request could not be fulfilled, because the required amount of Tx data is not available. The lower layer module may retry this call later on. No data has been copied. BUFREQ_E_NOT_OK: Data has not been copied. Request failed. Description This function is called to acquire the transmit data of an I-PDU segment (N-PDU). Each call to this function provides the next part of the I-PDU data unless retry->TpDataState is TP_ DATARETRY. In this case the function restarts to copy the data beginning at the offset from the current position indicated by retry->TxTpDataCnt. The size of the remaining data is written to the position indicated by availableDataPtr. Available via PduR_<module>.h ⌋