SNIP_CLASSIC_FEE_SECTION_8_3_9_Fee_EraseImmediateBlock

8.3.9 Fee_EraseImmediateBlock [SWS_Fee_00094] Definition of API function Fee_EraseImmediateBlock Upstream requirements: SRS_MemHwAb_14032 ⌈ Service Name Fee_EraseImmediateBlock Syntax Std_ReturnType Fee_EraseImmediateBlock ( uint16 BlockNumber ) Service ID [hex] 0x09 Sync/Async Asynchronous Reentrancy Non Reentrant Parameters (in) BlockNumber Number of logical block, also denoting start address of that block in EEPROM. Parameters (inout) None Parameters (out) None Return value Std_ReturnType E_OK: The requested job has been accepted by the module. E_NOT_OK: The requested job has not been accepted by the module. Description Service to erase a logical block. Available via Fee.h ⌋ Note: The function Fee_EraseImmediateBlock shall only be called by e.g. diagnostic or similar system service to pre-erase the area for immediate data if necessary. [SWS_Fee_00066] Upstream requirements: SRS_MemHwAb_14009 ⌈The function Fee_EraseImmediateBlock shall take the block number and calculate the corresponding memory block address.⌋ [SWS_Fee_00067] Upstream requirements: SRS_MemHwAb_14013 ⌈The function Fee_EraseImmediateBlock shall ensure that the FEE module can write immediate data. Whether this involves physically erasing a memory area and therefore calling the erase function of the underlying driver depends on the implementation of the module.⌋ [SWS_Fee_00127] Upstream requirements: SRS_BSW_00406 ⌈If development error detection is enabled for the module: the function Fee_EraseImmediateBlock shall check if the module state is MEMIF_UNINIT. If this is the case, the function Fee_EraseImmediateBlock shall raise the development error FEE_E_UNINIT.⌋ [SWS_Fee_00146] ⌈The function Fee_EraseImmediateBlock shall check if the module state is MEMIF_BUSY. If this is the case, the function Fee_EraseImmediateBlock shall reject the erase request, raise the runtime error FEE_E_BUSY and return with E_NOT_OK.⌋ [SWS_Fee_00068] Upstream requirements: SRS_BSW_00323 ⌈If development error detection is enabled for the module: the function Fee_EraseImmediateBlock shall check whether the addressed logical block is configured as containing immediate data (FeeImmediateData == TRUE). If not, the function Fee_EraseImmediateBlock shall raise the development error FEE_E_INVALID_ BLOCK_NO.⌋ [SWS_Fee_00141] Upstream requirements: SRS_BSW_00323 ⌈If development error detection is enabled for the module: the function Fee_EraseImmediateBlock shall check that the given block number is valid (i.e. it has been configured). If this is not the case, the function Fee_EraseImmediateBlock shall raise the development error FEE_E_INVALID_BLOCK_NO.⌋ [SWS_Fee_00166] Upstream requirements: SRS_MemHwAb_14032 ⌈If a erase request is rejected by the function Fee_EraseImmediateBlock, i.e. requirements [SWS_Fee_00068], [SWS_Fee_00127], [SWS_Fee_00141] or [SWS_Fee_00146] apply, the function Fee_EraseImmediateBlock shall not change the current module status or job result.⌋