SNIP_CLASSIC_FRIF_SECTION_8_4_8_FrIf_DisableLPdu

8.4.8 FrIf_DisableLPdu [SWS_FrIf_05710] Definition of API function FrIf_DisableLPdu ⌈ Service Name FrIf_DisableLPdu Syntax Std_ReturnType FrIf_DisableLPdu ( uint8 FrIf_CtrlIdx, uint16 FrIf_LPduIdx ) Service ID [hex] 0x28 Sync/Async Synchronous Reentrancy Non Reentrant for the same device FrIf_CtrlIdx Index of FlexRay CC within the context of the FlexRay Interface. Parameters (in) FrIf_LPduIdx This index is used to uniquely identify a FlexRay frame Parameters (inout) None Parameters (out) None Return value Std_ReturnType E_OK: API call finished successfully. E_NOT_OK: API call aborted due to errors. Description Wraps the FlexRay Driver Function Fr_DisableLPdu. It disables the hardware resource of an LPdu for transmission/reception. Available via FrIf.h ⌋ [SWS_FrIf_05418] ⌈The function FrIf_DisableLPdu shall be pre compile time configurable ON/OFF by the configuration parameter FrIfDisableLPduSupport (derived from configuration parameter FrIfDisableLPduSupport, see ECUC_FrIf_06110)⌋ [SWS_FrIf_05717] ⌈If development error detection for the FrIf module is enabled: if the function FrIf_DisableLPdu is called before the FrIf was initialized successfully, the function FrIf_DisableLPdu shall raise the development error FRIF_E_UNINIT and return E_ NOT_OK.⌋ [SWS_FrIf_05714] ⌈If development error detection for the FrIf module is enabled: the function FrIf_DisableLPdu shall check the parameter FrIf_CtrlIdx for being valid. If FrIf_ CtrlIdx is invalid, the function FrIf_DisableLPdu shall raise the development error FRIF_ E_INV_CTRL_IDX and return E_NOT_OK.⌋