SNIP_CLASSIC_FRTP_SECTION_8_3_3_3_FrTp_ChangeParameter

8.3.3.3 FrTp_ChangeParameter [SWS_FrTp_00151] Definition of API function FrTp_ChangeParameter ⌈ Service Name FrTp_ChangeParameter Syntax Std_ReturnType FrTp_ChangeParameter ( PduIdType id, TPParameterType parameter, uint16 value ) Service ID [hex] 0x4b Sync/Async Synchronous Reentrancy Non Reentrant id Identification of the PDU which the parameter change shall affect. parameter ID of the parameter that shall be changed. Parameters (in) value The new value of the parameter. Parameters (inout) None Parameters (out) None Return value Std_ReturnType E_OK: The parameter was changed successfully. E_NOT_OK: The parameter change was rejected. Description Request to change a specific transport protocol parameter (e.g. block size). Available via FrTp.h ⌋ Note: The service FrTp_ChangeParameter is used to change the transport protocol parameter Bandwidth Control (BC). [SWS_FrTp_01143] Raise development error when change parameter is called with invalid parameter ID ⌈If development error detection for the FrTp_ChangeParameter is enabled: the function FrTp_ChangeParameter shall check the parameter Id for being valid. If the check for Id fails, the function FrTp_ChangeParameter shall raise the development error FRTP_E_INVALID_PDU_SDU_ID and return E_NOT_OK.⌋ [SWS_FrTp_01144] Raise development error when change parameter is called with invalid parameter ⌈If development error detection for the FrTp_ChangeParameter is enabled: the function FrTp_ChangeParameter shall check the parameter for being valid. If the check for parameter fails, the function FrTp_ChangeParameter shall raise the development error FRTP_E_INVALID_PARAMETER and return E_ NOT_OK.⌋