SNIP_CLASSIC_INTEROPERABILITYOFAUTOSARTOOLS_SECTION_6_2_Notes_on_compliance

Specification of Interoperability of AUTOSAR Tools R4.1 Rev 3 Attribute Datatype Mul. Kind Note comConfig urationGw TimeBase TimeValue 0..1 attr The period between successive calls to Com_MainFunctionRouteSignals of the AUTOSAR COM module in seconds. comConfig urationRxT imeBase TimeValue 0..1 attr The period between successive calls to Com_MainFunctionRx of the AUTOSAR COM module in seconds. comConfig urationTxTi meBase TimeValue 0..1 attr The period between successive calls to Com_MainFunctionTx of the AUTOSAR COM module in seconds. comEnable MDTForCy clicTransm ission Boolean 0..1 attr Enables for the Com module of this EcuInstance the minimum delay time monitoring for cyclic and repeated transmissions (TransmissionModeTiming has cyclicTiming assigned or eventControlledTiming with numberOfRepetitions > 0). commCont roller Communication Controller 1..* aggr CommunicationControllers of the ECU. connector Communication Connector * aggr All channels controlled by a single controller. diagnostic Address Integer 0..1 attr An ECU specific ID for responses of diagnostic routines. partition EcuPartition * aggr Optional definition of Partitions within an Ecu. sleepMode Supported Boolean 1 attr Specifies whether the ECU instance may be put to a "low power mode" • true: sleep mode is supported • false: sleep mode is not supported Note: This flag may only be set to "true" if the feature is supported by both hardware and basic software. tpAddress TpAddress * ref Please note that this reference is deprecated and will be removed in future. A Tp Address can be assigned to an ECU without an existing TP Configuration. If TpNodes are described this reference shall not be used. Tags: atp.Status=obsolete; atp.StatusRevision Begin=4.1.3 wakeUpOv erBusSupp orted Boolean 1 attr Driver support for wakeup over Bus. Table C.11: EcuInstance