SNIP_CLASSIC_LINIF_SECTION_8_3_1_2_Lin_CheckWakeup

8.3.1.2 Lin_CheckWakeup [SWS_Lin_00160] Definition of API function Lin_CheckWakeup ⌈ Service Name Lin_CheckWakeup Syntax Std_ReturnType Lin_CheckWakeup ( uint8 Channel ) Service ID [hex] 0x0a Sync/Async Synchronous Reentrancy Non Reentrant Parameters (in) Channel LIN channel to be addressed Parameters (inout) None Parameters (out) None Return value Std_ReturnType E_OK: API call has been accepted E_NOT_OK: API call has not been accepted Description This function checks if a wakeup has occurred on the addressed LIN channel. Available via Lin.h ⌋ There are two methods in which wake up detection shall happen, one is from LIN controller hardware [Micro peripheral device] and/or another from LinTranceiver. [SWS_Lin_00098] Upstream requirements: SRS_BSW_00375, SRS_Lin_01563 ⌈The function Lin_CheckWakeup shall evaluate the wakeup on the addressed LIN channel. When a wake-up event on the addressed LIN channel (e.g. RxD pin has constant low level) is detected, the function Lin_CheckWakeup shall notify the ECU State Manager module immediately via the EcuM_SetWakeupEvent and the Lin Interface module via LinIf_WakeupConfirmation callback function.⌋ [SWS_Lin_00251] ⌈If development error detection for the LIN module is enabled: if the channel parameter is invalid, the function Lin_CheckWakeup shall raise the development error LIN_E_INVALID_CHANNEL otherwise (if DET is disabled) return E_NOT_OK.⌋ [SWS_Lin_00107] ⌈If development error detection for the LIN module is enabled: if the function Lin_CheckWakeup is called before the LIN module was initialized, the function Lin_CheckWakeup shall raise the development error LIN_E_UNINIT.⌋