SNIP_CLASSIC_LINSM_SECTION_7_1_4_LINSM_FULL_COM

7.1.4 LINSM_FULL_COM The LINSM_FULL_COM is the only state where communication on the LIN bus is allowed. Each network can be in LINSM_FULL_COM independent of each other. All of the following requirements are applicable for each network. [SWS_LinSM_00032] ⌈There shall be a sub-state called LINSM_FULL_COM for each network in the state LINSM_INIT.⌋ [SWS_LinSM_00033] ⌈When entering LINSM_FULL_COM the ComM shall be notified of the state change by calling the ComM_BusSM_ModeIndication with the parameter COMM_FULL_COMMUNICATION for the specified network.⌋ [SWS_LinSM_00192] ⌈When entering LINSM_FULL_COM the BswM shall be notified of the state change by calling the BswM_LinSM_CurrentState with the parameter LINSM_FULL_COM for the specified network.⌋ [SWS_LinSM_00205] ⌈When entering LINSM_FULL_COM the transceiver shall be set to active by using the LinIf_SetTrcvMode. This requirement is applicable only when LinSMTransceiverPassiveMode is configured for the channel.⌋ [SWS_LinSM_00301] ⌈When entering LINSM_FULL_COM, the sub-state LINSM_ RUN_COMMUNICATION will be entered.⌋