SNIP_CLASSIC_LINTRCV_SECTION_8_3_3_LinTrcv_GetOpMode

8.3.3 LinTrcv_GetOpMode [SWS_LinTrcv_00005] Definition of API function LinTrcv_GetOpMode Upstream requirements: SRS_BSW_00310, SRS_BSW_00369, SRS_BSW_00377 ⌈ Service Name LinTrcv_GetOpMode Syntax Std_ReturnType LinTrcv_GetOpMode ( uint8 LinNetwork, LinTrcv_TrcvModeType* OpMode ) Service ID [hex] 0x02 Sync/Async Synchronous Reentrancy Reentrant Parameters (in) LinNetwork LIN network to which API call has to be applied Parameters (inout) None ▽ △ Parameters (out) OpMode Pointer to operation mode of the bus the API is applied to. Return value Std_ReturnType E_OK: will be returned if the operation mode is detected E_NOT_OK: will be returned, if service request is failed due to operation mode is not detected. Description API detects the actual software state of LIN transceiver driver. Available via LinTrcv.h ⌋ [SWS_LinTrcv_00121] ⌈The function LinTrcv_GetOpMode shall return the actual state of the LIN transceiver driver in the parameter OpMode.⌋ [SWS_LinTrcv_00122] ⌈If there is no / incorrect communication to the transceiver, the function LinTrcv_GetOpMode shall return E_NOT_OK.⌋ [SWS_LinTrcv_00123] ⌈If development error detection for the module LinTrcv is enabled: If called before the LinTrcv module has been initialized, the function LinTrcv_GetOpMode shall report the development error LINTRCV_E_UNINIT.⌋ [SWS_LinTrcv_00124] ⌈If development error detection for the module LinTrcv is enabled: If called with an invalid network number LinNetwork, the function LinTrcv_GetOpMode shall report the development error LINTRCV_E_INVALID_LIN_NETWORK.⌋ [SWS_LinTrcv_00125] ⌈If development error detection for the module LinTrcv is enabled: If called with OpMode == NULL, the function LinTrcv_GetOpMode shall report the development error LINTRCV_E_PARAM_POINTER.⌋ Configuration: The number of supported busses is statically set in the configuration phase.