SNIP_CLASSIC_LIN_SECTION_8_3_2_3_Lin_GoToSleepInternal

8.3.2.3 Lin_GoToSleepInternal [SWS_Lin_00167] Definition of API function Lin_GoToSleepInternal ⌈ Service Name Lin_GoToSleepInternal Syntax Std_ReturnType Lin_GoToSleepInternal ( uint8 Channel ) ▽ △ Service ID [hex] 0x09 Sync/Async Synchronous Reentrancy Non Reentrant for the same Channel. Reentrant for different Channel. Parameters (in) Channel LIN channel to be addressed Parameters (inout) None Parameters (out) None Return value Std_ReturnType E_OK: Command has been accepted E_NOT_OK: Command has not been accepted, development or production error occurred Description Sets the channel state to LIN_CH_SLEEP, enables the wake-up detection and optionally sets the LIN hardware unit to reduced power operation mode (if supported by HW). Available via Lin.h ⌋ [SWS_Lin_00095] ⌈The function Lin_GoToSleepInternal shall set the channel state to LIN_CH_SLEEP.⌋ [SWS_Lin_00222] ⌈If external wake-up detection is supported by configuration parameter LinChannelWakeupSupport, then the function Lin_GoToSleepInternal shall enable bus monitoring for a wake-up request on that channel.⌋ [SWS_Lin_00223] ⌈The function Lin_GoToSleepInternal shall optionally set the LIN hardware unit to reduced power operation mode (if supported by HW).⌋ [SWS_Lin_00133] ⌈If development error detection for the LIN module is enabled: if the function Lin_GoToSleepInternal is called before the LIN module was initialized, the function Lin_GoToSleepInternal shall raise the development error LIN_E_UNINIT.⌋ [SWS_Lin_00135] ⌈If development error detection for the LIN module is enabled: the function Lin_GoToSleepInternal shall raise the development error LIN_E_INVALID_CHANNEL if the channel parameter is invalid.⌋