SNIP_CLASSIC_MEMIF_SECTION_8_3_9_Fls_SetMode

8.3.9 Fls_SetMode [SWS_Fls_00258] Definition of API function Fls_SetMode Upstream requirements: SRS_Fls_13302 ⌈ Service Name Fls_SetMode Syntax void Fls_SetMode ( MemIf_ModeType Mode ) Service ID [hex] 0x09 Sync/Async Synchronous Reentrancy Non Reentrant Parameters (in) Mode MEMIF_MODE_SLOW: Slow read access / normal SPI access. MEMIF_MODE_FAST: Fast read access / SPI burst access. Parameters (inout) None Parameters (out) None Return value None Description Sets the flash driver’s operation mode. Available via Fls.h ⌋ [SWS_Fls_00155] Upstream requirements: SRS_Fls_13302 ⌈The function Fls_SetMode shall set the FLS module’s operation mode to the given "Mode" parameter.⌋ [SWS_Fls_00156] Upstream requirements: SRS_Fls_13302 ⌈If runtime error detection for the module Fls is enabled: the function Fls_SetMode shall check that the FLS module is currently not busy. If this check fails, the function Fls_SetMode shall reject the set mode request and raise the development error code FLS_E_BUSY.⌋ [SWS_Fls_00187] Upstream requirements: SRS_BSW_00171, SRS_Fls_13302 ⌈The function Fls_SetMode shall be pre-compile time configurable On/Off by the configuration parameter FlsSetModeApi.⌋