SNIP_CLASSIC_OS_SECTION_8_4_24_StartCore

8.4.24 StartCore [SWS_Os_00676] Definition of API function StartCore Upstream requirements: SRS_Os_80006 ⌈ Service Name StartCore Syntax void StartCore ( CoreIdType CoreID, StatusType* Status ) Service ID [hex] 0x17 Sync/Async Synchronous Reentrancy Non Reentrant Parameters (in) CoreID Core identifier Parameters (inout) None Parameters (out) Status Return value of the function in extended status: E_OK: No Error E_OS_ID: Core ID is invalid. E_OS_ACCESS: The function was called after starting the OS. E_OS_STATE: The Core is already activated. Return value of the function in standard status E_OK: No Error Return value None Description It is not supported to call this function after StartOS(). The function starts the core specified by the parameter CoreID. The OUT parameter allows the caller to check whether the operation was successful or not. If a core is started by means of this function StartOS shall be called on the core. Available via Os.h ⌋ [SWS_Os_00677] Upstream requirements: SRS_Os_80006 ⌈The function StartCore shall start one core that shall run under the control of the AUTOSAR OS.⌋ [SWS_Os_00678] Upstream requirements: SRS_Os_80006 ⌈Calls to the StartCore function after StartOS shall return with E_OS_ACCESS and the core shall not be started.⌋ [SWS_Os_00679] Upstream requirements: SRS_Os_80006 ⌈If the parameter CoreIDs refers to a core that was already started by the function StartCore the related core is ignored and E_OS_STATE shall be returned.⌋ [SWS_Os_00681] Upstream requirements: SRS_Os_80006 ⌈There is no call to the ErrorHook if an error occurs during StartCore.⌋