SNIP_CLASSIC_WDGM_SECTION_7_7_2_Reset

7.7.2 Reset [SWS_EcuM_04005] Upstream requirements: SRS_ModeMgm_00023, SRS_ModeMgm_00012 ⌈The ECU Manager module shall define a configurable set of reset modes (see EcuMResetMode and EcuM_ResetType ), where each mode itself is a shutdown target. The set will minimally contain targets for • Mcu_PerformReset • WdgM_PerformReset • Toggle I/O Pin via DIO / SPI ⌋ [SWS_EcuM_04006] Upstream requirements: SRS_ModeMgm_00023, SRS_ModeMgm_00012 ⌈The ECU Manager module shall allow defining aliases for reset targets (See Ecu M180_Conf).⌋ [SWS_EcuM_04007] Upstream requirements: SRS_ModeMgm_00023, SRS_ModeMgm_00012 ⌈The ECU Manager module shall define a configurable set of reset causes (see EcuMShutdownCause and EcuM_ShutdownCauseType ). The set shall minimally contain targets for • ECU state machine entered a shutdown state • WdgM detected a failure • DCM requests shutdownI and the time of the reset.⌋ [SWS_EcuM_04008] Upstream requirements: SRS_ModeMgm_00023 ⌈The ECU Manager Module shall offer facilities to BSW modules and SW-Cs to • Record a shutdown cause • Get a set of recent shutdown causes ⌋ See also section 8.3.4 Shutdown Management.