SNIP_CLASSIC_WDG_SECTION_8_3_3_Wdg_SetTriggerCondition

8.3.3 Wdg_SetTriggerCondition [SWS_Wdg_00155] Definition of API function Wdg_SetTriggerCondition Upstream requirements: SRS_BSW_00343 ⌈ Service Name Wdg_SetTriggerCondition Syntax void Wdg_SetTriggerCondition ( uint16 timeout ) Service ID [hex] 0x03 Sync/Async Synchronous Reentrancy Non Reentrant Parameters (in) timeout Timeout value (milliseconds) for setting the trigger counter. Parameters (inout) None Parameters (out) None Return value None Description Sets the timeout value for the trigger counter. Available via Wdg.h ⌋ [SWS_Wdg_00136] ⌈The function Wdg_SetTriggerCondition shall reset the watchdog timeout counter according to the timeout value passed.⌋ [SWS_Wdg_00138] ⌈The timeout value passed shall be interpreted as ’milliseconds’. The conversion from milliseconds to the corresponding counter value shall be done internally by the Wdg module.⌋ [SWS_Wdg_00139] ⌈The current watchdog mode shall be taken into account when calculating the counter value from the timeout parameter.⌋ [SWS_Wdg_00140] ⌈This function shall also allow to set "0" as the time frame for triggering which will result in an (almost) immediate stop of the watchdog triggering and an (almost) instantaneous watchdog reset of the ECU. In case the counter value stored inside watchdog has the value "0", the service Wdg_SetTriggerCondition shall do nothing, which means it shall ignore the counter passed by the parameter to Wdg_ SetTriggerCondition.⌋ [SWS_Wdg_00146] ⌈When development error detection is enabled for the module: The function Wdg_SetTriggerCondition shall check that the timeout parameter given is less or equal to the maximum timeout value (WdgMaxTimeout). If this is not the case the function shall not reload the timeout counter but raise the development error WDG_ E_PARAM_TIMEOUT and return to the caller.⌋